Hostname: page-component-7b7567c8c-lpg2g Total loading time: 0 Render date: 2026-11-15T20:20:04.005Z Has data issue: false hasContentIssue false

Structure and Mechanical Properties of the Engine Valves with Intermetallic Disk

Published online by Cambridge University Press:  10 February 2011

B. N. Kodess
Affiliation:
ICS*VNIIMS, 46 Ozernaya St., Moscow, 119361
G. P. Teterin
Affiliation:
MSOU, 22 P. Korchagina St., Moscow 129805, Russia
L. A. Kommel
Affiliation:
TTU, 5 Enitajate, Tallin EE-0026, Estonia
V. K. Ovcharov
Affiliation:
VNIIMS, 46 Ozernaya St., Moscow, 119361;
Get access

Abstract

The bimetallic valves were produced using a new technique, IFFM (Impact Fused-Forging Modeling). Distribution of the alloy components as well as phase composition across the valve section was obtained by means of energy-dispersive analysis and X-ray diffraction. Optic and electron microscopy research of macro- and microstructure was conducted. High quality of the joint between the sintermetallic (TiAl) head and the titanium (VT-9 and VT-6 alloys) stem was demonstrated. As a result of the contact of the stem with the semi-solid intermetallics at the temperature above Tc, a polymorphous transformation was obtained in the upper part of the Ti-based stem. The globular microstructure in the intermetallic head in the area near to the joint of the two alloys was achieved. The results proved that the process allows production of complex shaped parts based on advanced alloys of high quality, featuring extra wear-resistance and strength.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable