Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T10:17:12.841Z Has data issue: false hasContentIssue false

Study of PZT Film Stress in Multilayer Structures for MEMS Devices

Published online by Cambridge University Press:  10 February 2011

E. Zakar
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783 ezakar@arl.mil
M. Dubey
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783
R. Polcawich
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783, GTS contractor
B. Piekarski
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783
R. Piekarz
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783
J. Conrad
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783
R. Widuta
Affiliation:
US Army Research Laboratory, Adelphi, MD 20783
Get access

Abstract

Residual stress in the multilayer Si/Dielectric/Pt/PZT/Pt stack was measured as a function of annealing conditions, sol-gel derived PZT (Lead Zirconate Titanate -52/48) thickness, SiO2 and/or Si3N4 dielectric films thickness. Residual stress in the Si3N4 layer varied from -201 to +1275 MPa and from -430 to + 511 MPa in the Si02 layer. Furnace annealing of the bottom Pt film reduced the stress over rapid thermal annealing (RTA). Stress due to PZT films was the controlling factor for the final stress of the stack. Upon increasing PZT thickness, stress became less tensile for Si3N4 dielectric and more tensile for Si02. The deposition of the top Pt on PZT followed by RTA at 300°C in nitrogen had a minimal effect on the final stress of the stack. The average tensile stress for the Si/Si02 /Pt/PZT/Pt and Si/Si3N4/Pt/PZT/Pt stacks was 140 ± 25 and 476±235 MPa respectively.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable