Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T22:42:43.357Z Has data issue: false hasContentIssue false

Studying Mechanical Properties Of Thin Films Under High Pressures

Published online by Cambridge University Press:  16 February 2011

B. C. Cai
Affiliation:
On temporary leave from Jiao Tong University, Shanghai, P. R. of China
D. Kuhlmann-Wilsdorf
Affiliation:
University of Virginia, Dept. of Materials Science, Charlottesville, VA 22901
R. B. Nelson
Affiliation:
University of Virginia, Dept. of Materials Science, Charlottesville, VA 22901
Get access

Abstract

Work-hardening curves of aluminum foils and of stacks of O.1μm thick 22 ct. gold foils, deformed between rotating Bridgman anvils, have been obtained for pressures up to 1533 MPa and shear strains to 400,000%. No sample thickness effect has been found between 5μm and 3μm, nor any significant difference between homogeneous foils and multi-layer foils, but heat-treatments do affect the results, as apparently does the introduction of 50nm thick sputtered copper layers between stacks of gold foils. Increases of strength with pressure appear to be due to corresponding increases of the Peierls-Nabarro stress. X-ray evidence indicates the reorientation of the foils from an initial (001) recrystallization texture after rolling to the (111) texture that was to be expected. Ordinary deformation behavior is indicated throughout, except for a tendency for slight negative work-hardening in the lower pressure range. At the extreme, assuming homogeneous deformation, the foils thinned to 60nm.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable