Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T08:40:50.470Z Has data issue: false hasContentIssue false

Surface modification of Ni/Ni3Al two-phase foils by electrochemically selective etching

Published online by Cambridge University Press:  24 October 2018

H.Y. Lee
Affiliation:
Department of Material Science and Engineering, KAIST, 335 Gwahangno, Yuseoung-gu, Daejeon, 305-701, KoreaFuel Cell Material Center, National Institute for Material Science, 1-2-1 Sengen, Tsukuba, Ibaraki, 305-0047, Japan
M. Demura
Affiliation:
Fuel Cell Material Center, National Institute for Material Science, 1-2-1 Sengen, Tsukuba, Ibaraki, 305-0047, Japan
Y. Xu
Affiliation:
Fuel Cell Material Center, National Institute for Material Science, 1-2-1 Sengen, Tsukuba, Ibaraki, 305-0047, Japan
D.M. Wee
Affiliation:
Department of Material Science and Engineering, KAIST, 335 Gwahangno, Yuseoung-gu, Daejeon, 305-701, Korea
T. Hirano
Affiliation:
Fuel Cell Material Center, National Institute for Material Science, 1-2-1 Sengen, Tsukuba, Ibaraki, 305-0047, Japan
Get access

Abstract

Surface morphology after the selective etching of the γ matrix was examined in Ni(γ)/Ni3Al(γ´) two-phase foils with various microstructures controlled by the 98 % cold rolling and subsequent heat treatment at 873, 1073 and 1273 K for 0.5 h. In the cold-rolled state, the elongated pancakeshape γ´ precipitates were distributed in the γ matrix, and this structure was almost the same after the heat treatment at 873 K though the recrystallization partly started. These γ´ pancakes were partitioned into the fine blocky particles of 10~100 nm in the edge after the heat treatment at 1073 K and the γ´ blocks significantly became larger at 1273 K. These foils were electrochemically etched in the electrolyte of distilled water with 1 wt.% (NH4)2SO4 and 1 wt.% citric acid at a constant potential of 1.75 V for 5 h. In this etching, the γ matrix was selectively dissolved and the γ´ precipitates were left behind, yielding rough and irregular surface. The surface morphologies corresponded to the γ/γ´ two-phase structures, thus demonstrating that the two-phase structure can be used as a template to make the surface area larger. The foil heattreated at 1073 K had a number of the fine γ´ particles with 10~100 nm in size densely dispersed on the surface. Such fine surface structure was expected to improve the catalytic activity of Ni3Al for the hydrogen production reaction.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable