Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T18:07:24.804Z Has data issue: false hasContentIssue false

Synthesis, Microstructure, and Mechanical Properties of FeCo-VC Composites

Published online by Cambridge University Press:  26 February 2011

Hongbin Bei
Affiliation:
Hbei1@utk.edu, The University of Tennessee, Materials science and Engineering, 1The University of Tennessee,, Department of Materials Science and Engineering, knoxville, TN, 37996-2200, United States, 865-5744343, 8655747659
E. P. George
Affiliation:
Georgeep@ornl.gov, Oak Ridge National Laboratory, Materials Science and Technology Division, Oak Ridge, TN, 37831-6115, United States
Get access

Abstract

Fe-Co-V-C quaternary alloys were drop cast and directionally solidified to obtain an in situ composite. It is found that the fully eutectic structure occurs at a composition of Fe - 40.5Co -10.4V- 8.6C (at. %) in a drop-cast alloy. Directional solidification of this composition in a high-temperature optical floating zone furnace produces a well-aligned microstructure, consisting of sub-micron VC fibers (~19% by volume) embedded in a FeCo-5V solid solution matrix containing ~ 1% C. The temperature dependencies of mechanical properties of this composite were examined by tensile tests and the composite was found to have higher yield strength and lower ductility than the matrix.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable