Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T17:37:53.402Z Has data issue: false hasContentIssue false

Ten Analyses Of Sol-Gel Derived And Sputtered PZT Thin Films

Published online by Cambridge University Press:  16 February 2011

Cheng-Chen Hsueh
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55455
Martha L. MeCartney
Affiliation:
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55455
Get access

Abstract

Ferroelectric PZT thin films were prepared by sol-gel methods and RF magnetron sputtering. Sputtered PZT fast fired at 650° for 30 minutes showed microporosity. For the sol-gel route, solution precursors had a significant effect on the microstructure of the crystalline PZT films. PZT thin films derived from metal-organic precursors dissolved in n-propanol were observed to have large and microporous spherulitic grains on the order of 2 μm and phase separation in acetic acid-catalyzed films. In contrast, PZT precursors originated from alcohol exchanges with 2-methoxyethanols resulted in dense films with fine grains of ∼0.2 μm and clear evidence of ferroelectric domains. The dense sol-gel films possessed superior dielectric and ferroelectric properties.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable