Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T13:07:49.589Z Has data issue: false hasContentIssue false

Thin Film Heater on a Thermally Isolated Microstructure

Published online by Cambridge University Press:  15 February 2011

Seajin Oh
Affiliation:
Teknekron Sensor Development Corporation, 1080 Marsh Road, Menlo Park, Ca. 94025
William Chu
Affiliation:
Teknekron Sensor Development Corporation, 1080 Marsh Road, Menlo Park, Ca. 94025
Sean Cahill
Affiliation:
Teknekron Sensor Development Corporation, 1080 Marsh Road, Menlo Park, Ca. 94025
Get access

Abstract

A microheater was fabricated on a thermally isolated silicon (Si) membrane and its electrical and thermomechanical properties were assessed. The sensor design was adjusted for good thermal isolation and good resistance to thermal shock. The heater was a platinum (Pt) thin-film meandering filament deposited with electron beam evaporation and patterned with lift-off methods. In order to operate the heater at high temperatures with minimum loss of Pt by evaporation, the heater was encapsulated with a ceramic film. During the heater operation, most of the heat was dissipated via conduction through the Si membrane which supported the multi-layered heater. When the Si membrane was completely etched away to suspend the heater, the power needed to heat the filament to strong incandescence (about 700–800°C) was 110 mW. Structural failure was not observed when the device was subjected to thermocycling up to approximately 500°C. The importance of the thermomechanical match of layers in a multi-layered heater structure, especially for use at high temperatures, is addressed.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable