Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T07:27:59.589Z Has data issue: false hasContentIssue false

A Titania Nanotube-Array Room-Temperature Sensor for Selective Detection of Low Hydrogen Concentrations

Published online by Cambridge University Press:  01 February 2011

Oomman K. Varghese
Affiliation:
Department of Electrical Engineering, and Department of Materials Science and Engineering 217 Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802, USA
Gopal K. Mor
Affiliation:
Department of Electrical Engineering, and Department of Materials Science and Engineering 217 Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802, USA
Maggie Paulose
Affiliation:
Department of Electrical Engineering, and Department of Materials Science and Engineering 217 Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802, USA
Craig A. Grimes
Affiliation:
Department of Electrical Engineering, and Department of Materials Science and Engineering 217 Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802, USA
Get access

Abstract

A tremendous variation in electrical resistance, from the semiconductor to metallic range, has been observed in titania nanotube arrays at room temperature, ≈ 25°C, in the presence of low ppm hydrogen gas concentrations (≤ 1000 ppm). The nanotube arrays are fabricated by anodizing titanium foil in an aqueous fluoride containing electrolyte solution. Subsequently, the arrays are annealed in an oxygen ambient, then coated with a 10 nm layer of palladium by evaporation. Electrical contacts are made by sputtering a small (e.g. 1 mm diameter) platinum disk atop the Pd coated nanotube-array. These sensors exhibit a resistance variation of the order of over 107 (1,000,000,000%) in the presence of 1000 ppm hydrogen at 23°C. To the best of our knowledge this dynamic change in electrical resistance the largest known response of any material, to any gas, at any temperature. The sensors demonstrate complete reversibility, repeatability, high selectivity, no drift and wide dynamic range. The nanoscale geometry of the nanotubes, in particular the points of tube-to-tube contact, is believed to be responsible for the outstanding hydrogen gas sensitivities.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable