Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T13:29:30.345Z Has data issue: false hasContentIssue false

Towards Large Area Diamond Substrates: The Mosaic Process

Published online by Cambridge University Press:  10 February 2011

Ger Janssen
Affiliation:
Research Institute for Materials, University of Nijmegen, Toernooiveld 1, 6525 ED Nijmegen, Netherlands.
John J. Schermer
Affiliation:
Research Institute for Materials, University of Nijmegen, Toernooiveld 1, 6525 ED Nijmegen, Netherlands.
L. J. Giling
Affiliation:
Research Institute for Materials, University of Nijmegen, Toernooiveld 1, 6525 ED Nijmegen, Netherlands.
Get access

Abstract

A method has been developed for producing large area single-crystal diamond plates, suitable for optical and electronic applications. It starts with orienting and closely packing a set of diamond seed crystals with (001) top faces. This assembly, or mosaic, is then joined by a single-crystal overgrowth using a CVD process. A number of assembling techniques have been tested for compatibility with homoepitaxial diamond growth by hot filament assisted CVD and/or growth and etching by the acetylene-oxygen combustion flame. Furthermore a two-step process is described. First an initial layer (20-50/μm) is deposited by hot filament assisted CVD at a low growth rate in order to bridge the gap between the seeds. Subsequently the fast growth rate of the acetylene-oxygen combustion flame is employed to increase the layer thickness (>250,μm). It was found that both the basic mosaic process as well as the two step process can produce a single-crystal diamond layer on top of mosaics consisting of seed crystals with well aligned crystallographic directions. The width of the gaps between the seed crystals (up to 25 μm) was found to be less critical, while the orientation of the side faces and the direction of the misorientation (i.e. the step flow direction) seem not to effect the successful overgrowth. Apart from the alignment of the seed crystals the most severe problem, which has to be overcome in order to obtain one single-crystal overgrowth, is the occurrence of penetration twins in the joint regions. The largest mosaic structure -up to now- overgrown by CVD consists of seven seed crystals and has a surface area slightly in excess of 1 cm2

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable