Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T02:05:28.011Z Has data issue: false hasContentIssue false

Two - Step Martensitic Transformations in TiNi(10% Cu) Shape Memory Alloys

Published online by Cambridge University Press:  25 February 2011

Warren J. Moberly
Affiliation:
Dept. of Materials Science & Engineering, Stevens Institute of Technology, Hoboken, NJ
T.W. Duerig
Affiliation:
Raychem Corporation, Menlo Park, CA
J.L. Proft
Affiliation:
Raychem Corporation, Menlo Park, CA
R. Sinclair
Affiliation:
Dept. Materials Science & Engineering, Stanford University, Stanford, CA
Get access

Abstract

Third element additions to TiNi provide a wide range of modifications of its shape memory properties. The advantages of Cu additions are to provide a more narrow hysteresis, less sensitivity to the Ti::Ni(+Cu) ratio of the temperature at which martensite starts to form (Ms), a larger strength differential between the austenite and martensite phases, and superior fatigue resistance. The substitution of a few atomic percent Cu for Ni does not significantly alter the crystal structure of either the cubic B2 austenite nor the monoclinic B19ʹ martensite phases; however, the addition of greater than 10% Cu results in an orthorhombic B19 martensite phase. For the case of 10% Cu, a two-step martensitic transformation occurs upon cooling, with the cubic austenite transforming to the orthorhombic B19 martensite and subsequently to the monoclinic B19ʹ martensite. As a result of this two-step crystallographic transformation, material properties such as resistivity and shape change also exhibit a two-step transformation.

In situ transmission electron microscopy heating and cooling experiments are used to observe the two-step martensitic transformation and to establish an orientation relationship between the B19 orthorhombic and the B19ʹ monoclinic structures. Strain vs temperature Ms tests establish the relative shape changes associated with both the cubic-to-orthorhombic transformation and the orthorhombic-to-monoclinic transformation. Similar Ms tests, where an applied load is removed during the transformation, establishes a crystallographic dependence between the two shape changes. Whereas binary TiNi is "trained" to undergo a specific shape change, this ternary TiNiCu alloy has a "natural" direction associated with the second step of its shape change.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable