Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T09:29:27.963Z Has data issue: false hasContentIssue false

Very-Low Surface Roughness in Laser Crystallized Polycrystalline Silicon

Published online by Cambridge University Press:  10 February 2011

K. Mourgues
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
L. Pichon
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
F. Raoult
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
T. Mohammed-Brahim
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
D. Briand
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
O. Bonnaud
Affiliation:
GMV Université Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
D. Lemoine
Affiliation:
LPS-INSA 35043 Rennes Cedex, France
P. Boher
Affiliation:
SOPRA S.A., 26 rue P. Joigneux, 92270 Bois-Colombes, France
M. Sthelé
Affiliation:
SOPRA S.A., 26 rue P. Joigneux, 92270 Bois-Colombes, France
J. L. Sthelé
Affiliation:
SOPRA S.A., 26 rue P. Joigneux, 92270 Bois-Colombes, France
Get access

Abstract

Excimer laser (ECL) crystallization of silicon films on low temperature substrates is one of the most promising technique for large-area polycrystalline silicon films. Crystallization techniques using pulsed-ECL were extensively studied. They are characterized by films with high structural and electrical properties but low uniformity. In this way, the technology using single shot ECL with very large excimer laser (VEL) may be very promising. It was used for the crystallization of amorphous undoped films deposited by PECVD or by LPCVD The LPCVD technique is the most commonly used deposition technique of silicon. It presents numerous advantages and the hydrogen content in the films, known to constitute a drawback in the crystallization process leading to an increased surface roughness, is negligible (∼1 at.%). However, even with these low hydrogen content LPCVD films, high surface roughness is observed after the laser crystallization. Hence surface roughness appears as one of the major problems to be solved in the high performance TFT's realization from laser crystallized films.

In this work, the reduction of the surface roughness, determined from Atomic Force Microscopy observations, is presented. This reduction originated from the use of a surface oxidation and an etch treatment to remove the oxide. The mean height of the roughness is then reduced by about 50%.

Using these low surface roughness polycrystalline films, TFT's are then realized.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable