Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T18:06:25.184Z Has data issue: false hasContentIssue false

W2B based High Thermal Stability Ohmic Contacts to n-GaN

Published online by Cambridge University Press:  01 February 2011

Rohit Khanna
Affiliation:
rohit25@ufl.edu, University of Florida, 1111 SW, 16th Avenue, Apt#1, Gainesville, Florida, 32601, United States
S J Pearton
Affiliation:
rohit25@ufl.edu, University of Florida, Department of Materials Science and Engineering
C J Kao
Affiliation:
rohit25@ufl.edu, National Central University, Department of Electrical Engineering, Taiwan
I I Kravchenko
Affiliation:
rohit25@ufl.edu, University of Florida, Department of Chemical Engineering, United States
F Ren
Affiliation:
rohit25@ufl.edu, University of Florida, Department of Chemical Engineering, United States
G C Chi
Affiliation:
rohit25@ufl.edu, National Central University, Department of Electrical Engineering, Taiwan
A Dabiran
Affiliation:
rohit25@ufl.edu, SVT Associates, Eden Prairie, MN, United States
A Osinsky
Affiliation:
rohit25@ufl.edu, SVT Associates, Eden Prairie, MN, United States
Get access

Abstract

A novel metallization scheme for Ohmic contact (Ti/Al/ W2B /Ti/Au) to n-GaN using high temperature boride was studied using contact resistance, scanning electron microscopy and Auger Electron Spectroscopy measurements. A minimum contact resistance of 7×10-6 Ω.cm2 was achieved for W2B based scheme at an annealing temperature of 800 °C. Contact resistances were found to be essentially independent of measurement temperature, indicating that tunneling plays a dominant role in the current transport. The outdiffusion of Ti to the surface at temperatures of ∼500°C, and at 800°C the onset of intermixing of Al within the contact was found to occur. By 1000°C, the contact showed a reacted appearance and AES showed almost complete intermixing of the metallization. The reliability measurements for the contact resistance of W2B based contact showed excellent stability for extended periods at 200°C, which simulates the type of device operating temperature that might be expected for operation of GaN-based power electronic devices.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable