Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T15:31:23.976Z Has data issue: false hasContentIssue false

X-ray Microbeam Investigation of Deformation Microstructure in Microindented Cu

Published online by Cambridge University Press:  15 February 2011

Wenge Yang
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
B. C. Larson
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
G. M. Pharr
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831University of Tennessee, Knoxville, Tennessee 37996
G. E. Ice
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
J. Z. Tischler
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
J. D. Budai
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
Wenjun Liu
Affiliation:
Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
Get access

Abstract

The deformation microstructure under spherical microindents in single crystal Cu has been investigated with submicron spatial resolution using x-ray structural microscopy. A polychromatic, submicron diameter (∼ 0.5 μm) microbeam was used in combination with micronresolution depth profiling to make direct, nondestructive measurements of plastic deformation induced lattice rotations under an indent made with a 69 μm radius spherical indenter and 200 mN maximum load. Lattice orientations relative to the undeformed crystal were determined as a function of position under the indent using differential-aperture x-ray structural microscopy (DAXM). Rotation-axes and misorientation-angles were determined for micron steps along selected microbeam penetration directions.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable