Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T08:57:36.885Z Has data issue: false hasContentIssue false

Young's Modulus and Fracture Strength of Three Polysilicons

Published online by Cambridge University Press:  17 March 2011

W. N. Sharpe Jr.
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218
K. Jackson
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218
G. Coles
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218
D. A. LaVan
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
Get access

Abstract

Polysilicon specimens from Cronos, Sandia, and Standard MEMS, Inc. were tested in tension. The specimens were nominally 6 or 20 μm wide and 250 or 1000 μm long. The Cronos and the Standard MEMS specimens had thicknesses of 1.5, 2.0, and 3.5 μm; whereas, the Sandia specimens were all 2.5 μm thick.

There was no dramatic difference in Young's modulus for the three materials. A total of 117 tests were run, and the average modulus for all three materials was 157 ± 9 GPa. However, the strengths were quite different: 1.56 ± 0.25 GPa for the Cronos material, 2.85 ± 0.40 GPa for Sandia's, and 2.04 ± 0.30 GPa for the SMI polysilicon.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable