Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T06:41:13.752Z Has data issue: false hasContentIssue false

Adding low-cost passive toe joints to the feet structure of SURENA III humanoid robot

Published online by Cambridge University Press:  22 November 2016

Majid Sadedel
Affiliation:
Center of Advanced Systems and Technologies (CAST), School of Mechanical Engineering, College of Engineering, University of Tehran, Tehran, Iran. E-mails: majid.sadedel@ut.ac.ir, m.mahdavian@ut.ac.ir
Aghil Yousefi-Koma*
Affiliation:
Center of Advanced Systems and Technologies (CAST), School of Mechanical Engineering, College of Engineering, University of Tehran, Tehran, Iran. E-mails: majid.sadedel@ut.ac.ir, m.mahdavian@ut.ac.ir
Majid Khadiv
Affiliation:
Center of Excellence in Robotics and Control, Advanced Robotics & Automated Systems (ARAS) Lab, Department of Mechanical Engineering, K. N. Toosi University of Technology, Tehran, Iran. E-mail: mkhadiv@mail.kntu.ac.ir
Mohhamad Mahdavian
Affiliation:
Center of Advanced Systems and Technologies (CAST), School of Mechanical Engineering, College of Engineering, University of Tehran, Tehran, Iran. E-mails: majid.sadedel@ut.ac.ir, m.mahdavian@ut.ac.ir
*
*Corresponding author. E-mail: aykoma@ut.ac.ir
Rights & Permissions [Opens in a new window]

Summary

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Adding active toe joints to a humanoid robot structure has lots of difficulties such as mounting a small motor and an encoder on the robot feet. Conversely, adding passive toe joints is simple, since it only consists of a spring and a damper. Due to lots of benefits of implementing passive toe joints, mentioned in the literature, the goal of this study is to add passive toe joints to the SURENA III humanoid robot which was designed and fabricated at the Center of Advanced Systems and Technologies (CAST), University of Tehran. To this end, a simple passive toe joint is designed and fabricated, at first. Then, stiffness and damping coefficients are calculated using a vision-based measurement. Afterwards, a gait planning routine for humanoid robots equipped with passive toe joints is implemented. The tip-over stability of the gait is studied, considering the vibration of the passive toe joints in swing phases. The multi-body dynamics of the robot equipped with passive toe joints are presented using the Lagrange approach. Furthermore, system identification routine is adopted to model the dynamic behaviors of the power transmission system. By adding the calculated actuating torques for these two models, the whole dynamic model of the robot is computed. Finally, the performance of the proposed approach is evaluated by several simulations and experimental results. Results show that using passive toe joints reduces energy consumption of ankle and knee joints by 15.3% and 9.0%, respectively. Moreover, with relatively large values of stiffness coefficients, the required torque and power of the knee and hip joints during heel-off motion reduces as the ankle joint torque and power increases.

Information

Type
Articles
Copyright
Copyright © Cambridge University Press 2016