Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T18:12:58.230Z Has data issue: false hasContentIssue false

Force-closure analysis of 6-DOF cable manipulators with seven or more cables

Published online by Cambridge University Press:  01 March 2009

Xiumin Diao
Affiliation:
Department of Mechanical and Aerospace Engineering, New Mexico State University, Las Cruces, NM 88003, USA
Ou Ma*
Affiliation:
Department of Mechanical and Aerospace Engineering, New Mexico State University, Las Cruces, NM 88003, USA
*
*Corresponding author. E-mail: oma@nmsu.edu
Rights & Permissions [Opens in a new window]

Summary

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

A cable manipulator controls its end-effector by a number of cables. If the cables can balance any external and inertia wrenches at a certain pose of the end-effector, the cable manipulator is said to have a force-closure at this pose. Since a cable can work only in tension, the force-closure at a specific pose may not exist. Thus, how to check the existence of force-closure at a given pose is an important issue for design and control of cable manipulators. This paper describes a systematic method of verifying the existence of force-closure at a specific pose of a general 6-DOF cable manipulator with seven or more cables. By examining the Jacobian matrix of the manipulator, the method can determine whether a force-closure exists at the pose corresponding to the Jacobian matrix. The necessity and sufficiency of the proposed method are mathematically proven. Moreover, a convex-analysis-based simplification of the method for manipulators with more than seven cables is also discussed.

Information

Type
Article
Copyright
Copyright © Cambridge University Press 2008