Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T20:07:50.700Z Has data issue: false hasContentIssue false

Optimal sliding mode control design based on the state-dependent Riccati equation for cooperative manipulators to increase dynamic load carrying capacity

Published online by Cambridge University Press:  09 October 2018

A. H. Korayem
Affiliation:
Robotic Research Laboratory, Center of Excellence in Experimental Solid Mechanics and Dynamics, School of Mechanical Engineering, Iran University of Science and Technology, Tehran 1684613114, Iran. E-mails: habibnejad1371@yahoo.com, saerafee@yahoo.com
S. R. Nekoo
Affiliation:
Robotic Research Laboratory, Center of Excellence in Experimental Solid Mechanics and Dynamics, School of Mechanical Engineering, Iran University of Science and Technology, Tehran 1684613114, Iran. E-mails: habibnejad1371@yahoo.com, saerafee@yahoo.com
M. H. Korayem*
Affiliation:
Robotic Research Laboratory, Center of Excellence in Experimental Solid Mechanics and Dynamics, School of Mechanical Engineering, Iran University of Science and Technology, Tehran 1684613114, Iran. E-mails: habibnejad1371@yahoo.com, saerafee@yahoo.com
*
*Corresponding author: E-mail: hkorayem@iust.ac.ir
Rights & Permissions [Opens in a new window]

Summary

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Cooperative manipulators have uncertainties in their structure; therefore, an optimal sliding mode control method is derived from a combination of the sliding mode control (SMC) and the state-dependent Riccati equation (SDRE) technique. This proposed combination is applied to a class of non-linear closed-loop systems. One of the distinguished features of this control method is its robustness toward uncertainty. Due to the lack of optimality in the SMC method, in this paper, a robust and optimal method is presented by considering the SDRE in design of the sliding surface. Due to the fact that cooperative manipulators have been used for carrying loads, the percentage of load distributions between each manipulator has been derived to increase the dynamic load carrying capacity (DLCC). The proposed control structure is implemented on a Scout robot with two manipulators in cooperative mode, theoretically and practically using LabVIEW software; and the results were compared by considering the uncertainty in its structure. In comparison with the SDRE, the proposed method increased the DLCC almost 10% in the Scout case.

Information

Type
Articles
Copyright
Copyright © Cambridge University Press 2018