Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T22:49:24.151Z Has data issue: false hasContentIssue false

Effect of the Doping and the Al Content on the Microstructure and Morphology of Thin AlxGa1−xN Layers Grown by MOCVD

Published online by Cambridge University Press:  13 June 2014

J.H. Mazur
Affiliation:
E.O. Lawrence Berkeley National Laboratory, MS 62-203, Berkeley, CA 94720
M. Benamara
Affiliation:
E.O. Lawrence Berkeley National Laboratory, MS 62-203, Berkeley, CA 94720
Z. Liliental-Weber
Affiliation:
E.O. Lawrence Berkeley National Laboratory, MS 62-203, Berkeley, CA 94720
W. Swider
Affiliation:
E.O. Lawrence Berkeley National Laboratory, MS 62-203, Berkeley, CA 94720
J. Washburn
Affiliation:
E.O. Lawrence Berkeley National Laboratory, MS 62-203, Berkeley, CA 94720
C.J. Eiting
Affiliation:
Microelectronics Research Center, The University of Texas at Austin, TX 78712
R. D. Dupuis
Affiliation:
Microelectronics Research Center, The University of Texas at Austin, TX 78712

Abstract

AlxGa1−xN {x=30% (doped and undoped), 45% (doped)} thin films were grown by MOCVD on ∼2 μm thick GaN layer using Al2O3 substrate. These films were designed to be the active parts of HFETs with nsμ product of about 1016(Vs)-1. The layers were then studied by means of transmission electron microscopy (TEM) techniques. In this paper, it is shown that the AlxGa1−xN layer thickness was non-uniform due to the presence of V-shaped defects within the AlxGa1−xN films. The nucleation of these V-shaped defects has taken place about 20 nm above the AlxGa1−xN/GaN interface. Many of these V-shaped defects were associated with the presence of the threading dislocations propagating from the GaN/Al2O3 interface. We show that the density of these V-shaped defects increases with the doping level and also with the Al mole fraction in the films. The formation mechanism of the V-shaped defects seems to be related to the concentration of dopants or other impurities at the ledges of the growing film. This suggestion is supported by high resolution TEM analysis. The growth front between the V-shaped defects in the lower Al concentration thin films was planar as compared with the three-dimensional growth in the doped, higher Al concentration film. This interpretation of the origin of the V-shaped defects is consistent with the observed lowering of the Schottky barrier height in n-doped AlGaN/Ni Schottky diodes.

Information

Type
Research Article
Copyright
Copyright © 1996 Materials Research Society
Figure 0

Fig 1:Weak beam g=[0002] image of an undoped 30% AlGaN layer (sample 1170) layer on about 1.7-2 μ GaN layer on a sapphire substrate. Note presence of V-shaped defects. In many cases these defects appear to be associated with the threading dislocations.

Figure 1

Fig 2:High resolution image of an undoped AlGaN layer (sample 1170) layer on ∼1.7-20μm GaN on a sapphire substrate showing V-shaped defects. Note that the growth between V-shaped defects is planar (2D). The V- shaped defect to the left initiated about 200 nm away from the AlGaN /GaN interface.

Figure 2

Fig 3:TEM bright field image of the cross-section of a doped 30% AlGaN layer on ∼2 μm GaN on a sapphire substrate (sample 1134B).

Figure 3

Fig 4:High resolution TEM image of the cross-section of a doped 30% AlGaN layer on ∼2 μm GaN on a sapphire substrate (sample 1134B).

Figure 4

Fig5:Bright field TEM image of the cross-section of a doped 45% AlGaN layer on ∼2 μm GaN on a sapphire substrate (sample 1129A).

Figure 5

Fig 6:High resolution TEM image of a doped 45% AlGaN layer on ∼2 μm GaN on a sapphire substrate (sample 1129A). Careful analysis of the growth front between V-shaped defects indicates 3D growth.

Figure 6

Fig7:Frequency of the observation of the V-shaped defect as a function of the separation between two consecutive V defects is the highest for a doped sample with highest Al content and the lowest for the undoped lower Al content sample.