Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T02:45:32.199Z Has data issue: false hasContentIssue false

Polythermal modelling of steady states of the Antarctic ice sheet in comparison with the real world

Published online by Cambridge University Press:  20 January 2017

I. Hansen
Affiliation:
Department of Mechanics, Technische Hochschule Darmstadt, D-64289 Darmstadt, Germany
R. Greve
Affiliation:
Department of Mechanics, Technische Hochschule Darmstadt, D-64289 Darmstadt, Germany
Rights & Permissions [Opens in a new window]

Abstract

An approach to simulate the present Antarctic ice sheet with reaped to its thermomechanical behaviour and the resulting features is made with the three-dimensional polythermal ice-sheet model designed by Greve and Hutter. It treats zones of cold and temperate ice as different materials with their own properties and dynamics. This is important because an underlying layer of temperate ice can influence the ice sheet as a whole, e.g. the cold ice may slide upon the less viscous binary ice water mixture.

Measurements indicate that the geothermal heat flux below the Antarctic ice sheet appears to be remarkably higher than the standard value of 42 m W m−2 that is usually applied for Precambrian shields in ice-sheet modelling. Since the extent of temperate ice at the base is highly dependent on this heat input from the lithosphere, an adequate choice is crucial for realistic simulations. We shall present a series of steady-state results with varied geothermal heat flux and demonstrate that the real ice-sheet topography can be reproduced fairly well with a value in the range 50–60 m W m−2. Thus, the physical parameters of ice (especially the enhancement factor in Glen’s flow law) as used by Greve (1995) for polythermal Greenland ice-sheet simulations can be adopted without any change. The remaining disagreements may he explained by the neglected influence of the ice shelves, the rather coarse horizontal resolution (100 km), the steady-state assumption and possible shortcomings in the parameterization of the surface mass balance.

Information

Type
Research Article
Copyright
Copyright © International Glaciological Society 1996
Figure 0

Table 1.1Values for physical quantities used in the model calculations

Figure 1

Fig. 1.Observed free-surface topography after Drewry (1983). Equidistunce of the contours is 500 m.

Figure 2

Fig. 2.Steady-state free-surface topography for the model runs described in the text with differing genthermal heat flux (lower lefthand corner Qgeoth in m W m−2); all other conditions are the same. Equidistance of the contours is 500 m.

Figure 3

Fig. 3.Isotherms of the steady-state homologous basal temperature shown as solid lines, the homologous temperature being indicated in °C. Open diamond symbols indicate positions where the basal ice is at the pressure-inciting point but with no temperate layer above; solid diamonds (solid circles) indicate positions where there is a basal layer of temperate ice with melting (freezing) CTS. Numbers in the lower lefthand corner give Qgeoth in m W m−2; all other conditions are the same.

Figure 4

Fig. 4.Model output for (a) total ice volume vtot, the dashed line indicating the observed value; (b) maximum ice thickness Hmax(solid diamonds) and maximum height of the ice shed hmax(open diamonds) with the corresponding observed values indicated by a thin solid line for Hmaxand a thin dashed line forhmax; (c) maximum thickness of the temperate-ice layer Ht,max; all are displayed as a function of the geothermal heat flux Qgeoth.