Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T19:48:37.156Z Has data issue: false hasContentIssue false

Characterization of Hot-Electron Effects on Flicker Noise in III-V Nitride Based Heterojunctions

Published online by Cambridge University Press:  13 June 2014

W.Y. Ho
Affiliation:
a)Department of Electronic Engineering, The Hong Kong Polytechnic University, Hong Kong.
W.K. Fong
Affiliation:
a)Department of Electronic Engineering, The Hong Kong Polytechnic University, Hong Kong.
Charles Surya
Affiliation:
a)Department of Electronic Engineering, The Hong Kong Polytechnic University, Hong Kong.1)e-mail address: ensurya@polyu.edu.hk
K.Y. Tong
Affiliation:
a)Department of Electronic Engineering, The Hong Kong Polytechnic University, Hong Kong.
L.W. Lu
Affiliation:
b)Department of Physics, The Hong Kong University of Science and Technology, Hong Kong.2)Permanent address: Laboratory of Semiconductor Materials Sciences, Institute of Semiconductors, Chinese Academy of Sciences, P.O. Box 912, Beijing 100083, P.R. China.
W.K. Ge
Affiliation:
b)Department of Physics, The Hong Kong University of Science and Technology, Hong Kong.

Abstract

We report experiments on hot-electron stressing in commercial III-V nitride based heterojunction light-emitting diodes. Stressing currents ranging from 100 mA to 200 mA were used. Degradations in the device properties were investigated through detailed studies of the I-V characteristics, electroluminescence, Deep-Level Transient Fourier Spectroscopy and flicker noise. Our experimental data demonstrated significant distortions in the I-V characteristics. The room temperature electroluminescence of the devices exhibited 25% decrement in the peak emission intensity. Concentration of the deep-levels was examined by measuring the Deep-Level Transient Fourier Spectroscopy, which indicated an increase in the density of deep-traps from 2.7 × 1013 cm−3 to 4.21 × 1013 cm−3 at E 1 = E C − 1.1eV. The result is consistent with our study of 1/f noise, which exhibited up to three orders of magnitude increase in the voltage noise power spectra. Our experiments show large increase in both the interface traps and deep-levels resulted from hot-carrier stressing.

Information

Type
Research Article
Copyright
Copyright © 1999 Materials Research Society
Figure 0

Fig. 1:Typical room temperature I-V characteristics of the LED before hot-electron stressing (curve A) and after 40 minutes of hot-electron stressing at 100 mA (curve B).

Figure 1

Fig. 2:Typical room temperature electroluminescence of the device before hot-electron stressing (curve A) and after 40 minutes of hot-electron stressing at 100 mA (curve B).

Figure 2

Fig. 3:DLTFS signal for the pre-stressed device (curve A) and the stressed device (curve B).

Figure 3

Fig. 4:The frequency exponent, γ, of SV(f) versus device temperature before current stressing (solid circles) and after stressing (solid squares).

Figure 4

Fig. 5:The normalized voltage noise power spectra, SV(f)/V2, at f = 500 Hz versus device temperature before stressing (solid circles) and after stressing (solid squares).

Figure 5

Fig. 6:Typical voltage noise power spectra, SV(f), for the pre-stressed device (curve A) and the stressed device (curve B) measured with a biasing current of 0.7 mA.