Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T10:08:13.360Z Has data issue: false hasContentIssue false

Near-surface turbulence and buoyancy induced by heavy rainfall

Published online by Cambridge University Press:  03 October 2017

E. L. Harrison
Affiliation:
Naval Surface Warfare Center, Carderock Division, 9500 Macarthur Boulevard, West Bethesda, MD 20817, USA
F. Veron*
Affiliation:
University of Delaware, School of Marine Science and Policy, Newark, DE 19716, USAUniversité de Bordeaux, I2M, CNRS UMR 5295, 16 avenue Pey-Berland, 33607 Pessac, France
*
†Email address for correspondence: fveron@udel.edu

Abstract

We present results from experiments designed to measure near-surface turbulence generated by rainfall. Laboratory experiments were performed using artificial rain falling at near-terminal velocity in a wind–wave channel filled with synthetic seawater. In this first series of experiments, no wind was generated and the receiving seawater was initially at rest. Rainfall rates from 40 to $190~\text{mm}~\text{h}^{-1}$ were investigated. Subsurface turbulent velocities of the order of $O(10^{-2})~\text{m}~\text{s}^{-1}$ are generated near the interface below the depth of the cavities generated by the rain drop impacts. The turbulence appears independent of rainfall rates. At depth larger than the size of the cavities, the turbulent velocity fluctuations decay as $z^{-3/2}$ . Turbulent length scales also appear to scale with the size of the impact cavities. In these seawater experiments, a freshwater lens is established at the water surface due to the rain. At the highest rain rate studied, the resulting buoyancy flux appears to lead to a shallower subsurface mixed layer and a slight decrease of the turbulent kinetic energy dissipation. Finally, direct measurements and inertial estimates of the turbulent kinetic energy dissipation show that approximately 0.1–0.3 % of the kinetic energy flux from the rain is dissipated in the form of turbulence. This is consistent with existing freshwater measurements and suggests that high levels of dissipation occur at depths and scales smaller than those resolved here and/or that other phenomena dissipate a considerable amount of the total kinetic energy flux provided by rainfall.

Information

Type
Papers
Copyright
© 2017 Cambridge University Press 
Figure 0

Figure 1.A diagram of the flume experimental section and the instrumentation set-up. Imaging techniques are represented with each camera’s numbered field of view: cameras 1 and 2 are used for the PIV and LIF techniques, imager 3 is the rain properties camera (RPC) and camera 4 is the laser wave-height gauge (LWG) and the laser slope gauge (LSG) positions sensor has a field of view shown as number 5. A fast response temperature, $T$, and conductivity, $\unicode[STIX]{x1D70E}$, sensor was profiled vertically downwind of the imaging area. For convenience, distances are given from the end of the flume.

Figure 1

Figure 2.(a) A raw image acquired with camera 1 showing high rain conditions. Intensity and filtering allows for the separation of images containing PIV particles (b) and LIF (c). (d) Shows an example PIV velocity output interpolated to the final grid (for clarity, only $1/3$ of the vectors in each direction are shown).

Figure 2

Figure 3.Three density fluctuation fields $\unicode[STIX]{x1D70C}^{\prime }(x,z)$, for times $t=82.9$, 289.8 and 496.7 s (a–c) after the start of rain with $R=190~\text{mm}~\text{h}^{-1}$. The image pair combined surface, $\unicode[STIX]{x1D702}^{\ast }(x)$, is shown with a solid black line. Data gaps exist below $\unicode[STIX]{x1D702}^{\ast }(x)$ because the cameras were not calibrated above the mean water level.

Figure 3

Figure 4.Profiles obtained with the $T{-}\unicode[STIX]{x1D70E}$ varying with time for $R=40~\text{mm}~\text{h}^{-1}$ showing (a) the temperature, $T$, (b) the salinity, $S$, and (c) the density, $\unicode[STIX]{x1D70C}$, (computed using both the $T$ and conductivity, $\unicode[STIX]{x1D70E}$, signals). The profiles are plotted up to the instantaneous surface $z_{\unicode[STIX]{x1D702}}$. The solid and dashed white lines indicate the time when rain starts and when a constant rain rate is achieved, respectively.

Figure 4

Figure 5.Six images acquired with PIV/LIF camera 1 are shown to visualize the evolution of the rain-induced mixed layer. Rain is falling the initially still saltwater surface with $R=40~\text{mm}~\text{h}^{-1}$.

Figure 5

Figure 6.The normalized, instantaneous fluctuating density, $\unicode[STIX]{x1D70C}^{\prime }\unicode[STIX]{x1D70C}_{b}^{-1}$, is shown for rain falling on a saltwater surface and for $R$ of (a) $40~\text{mm}~\text{h}^{-1}$, (b) $100~\text{mm}~\text{h}^{-1}$ and (c) $190~\text{mm}~\text{h}^{-1}$. Here, $\unicode[STIX]{x1D70C}^{\prime }\unicode[STIX]{x1D70C}_{b}^{-1}$ was measured with the profiled $T{-}\unicode[STIX]{x1D70E}$ sensor. The solid white line indicates the start of rainfall while the dashed white line indicates a constant rain rate $R$ has been achieved.

Figure 6

Figure 7.The normalized r.m.s. fluctuating density measured with the $T{-}\unicode[STIX]{x1D70E}$ sensor, $\overline{(\unicode[STIX]{x1D70C}^{\prime })^{2}}^{1/2}\unicode[STIX]{x1D70C}_{b}^{-1}$, for $180\leqslant t<300~\text{s}$ where $t=0$ is the start of the rain. The bulk salinity is $S_{b}=37~\text{psu}$. Depth is normalized by the drop radius $r$.

Figure 7

Figure 8.Time series of the mean turbulent kinetic energy profiles, $KE_{t}$, are shown for $R$ of (a) $40~\text{mm}~\text{h}^{-1}$, (b) $100~\text{mm}~\text{h}^{-1}$ and (c) $190~\text{mm}~\text{h}^{-1}$. The solid black line indicates the start of rainfall while the dashed black line indicates a constant rain rate $R$ has been achieved. The bulk salinity is ($S_{b}=37.45\pm 0.15~\text{psu}$).

Figure 8

Figure 9.Time averaged r.m.s. fluctuating velocity components, (a) $\overline{\langle u_{1}^{\prime 2}\rangle }^{1/2}$ and (b) $\overline{\langle u_{3}^{\prime 2}\rangle }^{1/2}$ for $180\leqslant t<300~\text{s}$ where $t=0$ is the start of the rain. Above the depth of the cavity $r_{c}$ the data obtained with PIV do not resolve the rapid motion and the velocity associated with the cavity formation and collapse. These data are likely underestimated and therefore presented here in light grey (see § 2.3.1). Also the solid red upward and blue downward triangles show the data of Beya et al. (2011) for $R=141~\text{mm}~\text{h}^{-1}$ and $R=108~\text{mm}~\text{h}^{-1}$ respectively. The solid and dashed lines show the PIV data of Braun (2003) for $R=8~\text{mm}~\text{h}^{-1}$ and $R=216~\text{mm}~\text{h}^{-1}$ respectively. Solid symbols at the top of the graphs show r.m.s. velocity estimates obtained from direct measurements of the surface displacements, $U_{w}$ and $U_{R}$, a velocity scale derived from the total kinetic energy from the rain. The grey curve show the expected r.m.s. orbital velocities from the ring waves.

Figure 9

Figure 10.Average turbulent kinetic $\overline{[KE_{t}]}$ as a function of rain rate.

Figure 10

Figure 11.Time averages of (a) the mean turbulent kinetic energy dissipation $\overline{\unicode[STIX]{x1D700}}$ and (b) the turbulent buoyancy flux $\overline{B_{t}}$ for $180\leqslant t<300~\text{s}$. Turbulent kinetic energy is produced (respectively destroyed) by buoyancy where $\overline{B_{t}}>0$ (respectively $\overline{B_{t}}<0$). Above the depth of the cavity $r_{c}$ the data obtained with PIV do not resolve the rapid motion and the velocity associated with the cavity formation and collapse. These data are likely underestimated and therefore presented here in light grey (see § 2.3.1). The faded symbol in (a) are excluded from the depth average shown in figure 12.

Figure 11

Figure 12.(a) Average turbulent kinetic energy dissipation $\overline{[\unicode[STIX]{x1D700}]}$, and (b) average turbulent buoyancy production $\overline{[B_{t}]}$.

Figure 12

Figure 13.$Fr$–$We$ parameter space graph showing different drop impact regimes. The approximate regimes for coalescing, floating and bouncing drops are separated with grey dashed lines. The black dash lines $Fr^{1/4}$ and $Fr^{1/5}$ show regimes where bubble entrainment is observed. The solid black line shows rainfall terminal velocity along with the drop radius (black) and the impact velocity $|\boldsymbol{v}_{I}|$ (grey in parenthesis). The solid black circle shows $Fr$ and $We$ for these experiments. (Adapted from Liow 2001).

Figure 13

Figure 14.Average Taylor microscale profiles $\overline{\unicode[STIX]{x1D706}_{T}}$ as a function of rain rate. Above the depth of the cavity $r_{c}$ the data obtained with PIV do not resolve the rapid motion and the velocity associated with the cavity formation and collapse. These data are likely underestimated and therefore presented here in light grey (see § 2.3.1).