Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T19:16:04.093Z Has data issue: false hasContentIssue false

Interface Effects on the Persistent Photoconductivity in Thin GaN and AlGaN Films

Published online by Cambridge University Press:  13 June 2014

O. P. Seifert
Affiliation:
University of Oldenburg, FB8/EHF, D-26129 Oldenburg
O. Kirfel
Affiliation:
University of Oldenburg, FB8/EHF, D-26129 Oldenburg
M. Munzel
Affiliation:
University of Oldenburg, FB8/EHF, D-26129 Oldenburg
M. T. Hirsch
Affiliation:
University of Oldenburg, FB8/EHF, D-26129 Oldenburg
J. Parisi
Affiliation:
University of Oldenburg, FB8/EHF, D-26129 Oldenburg
M. Kelly
Affiliation:
Technical University of Munich, Walter Schottky Institute, D-85748 Garching
O. Ambacher
Affiliation:
Technical University of Munich, Walter Schottky Institute, D-85748 Garching
M. Stutzmann
Affiliation:
Technical University of Munich, Walter Schottky Institute, D-85748 Garching

Abstract

Thin films of GaN and its alloy AlGaN are investigated with respect to their properties of the persistent photoconductivity (PPC). In this work, we show that the film-substrate interface plays an important role for the metastable electrical effect. Strongly absorbed bandgap light causes an increase of photoconductivity which is about one order of magnitude higher when the sample is illuminated from the substrate side near the interface than from the growth side. To access the interface properties at the substrate, we use temperature-dependent Hall effect measurements. The smallest PPC effect was observed for the GaN film with the best interface properties grown on SiC.

Information

Type
Research Article
Copyright
Copyright © 1999 Materials Research Society
Figure 0

Fig. 1:Comparison of excess conductivity transients under different illumination conditions for a GaN sample grown on sapphire. The dotted line results from illumination from the frontside, the solid line from illumination from the substrate side (backside). At t=0s, the first illumination cycle with strongly absorbed bandgap light (λ=300nm) is started. The second cycle of illumination with subbandgap light of λ=434nm starts at ∼5 × 104s. For the subbandgap light illumination, both transients exhibit about the same value at the end of illumination. But for illumination with strongly absorbed bandgap light, the excess conductivity is by a factor of ten higher when illuminated through the substrate (i.e., light absorption takes place near the substrate-GaN interface) than illuminated from the growth side.

Figure 1

Fig. 2.Conductivity after 14400s of illumination versus the photon energy used for excitation. The dashed and dotted lines are linear fits to the data. The intersection with the energy axis yields an estimation for the lower threshold energy limit Eth for optical excitation.(a)We find a difference in threshold energy for GaN (Eth=1.1eV) and Al0.15Ga0.85N (Eth=1.6eV) which compares well with the differences of their bandgap energies. The inset shows a typical conductivity transient: illumination with λ=434nm starts at t=0 and ends at t=14400s.(b)A comparison between two samples with and without buffer yields a threshold energy of Eth=0.5eV for the sample with 50nm GaN buffer and Eth=1.1eV for the sample without buffer.

Figure 2

Fig. 3(a)Effective Hall-carrier concentration nH versus temperature T measured for sample SI3 (GaN/sapphire), SM1 (GaN/GaN-Buffer/sapphire), and SI6 (GaN/SiC). The left vertical axis is for the open symbols, the right vertical axis belongs to the filled symbols.

Figure 3

Fig. 3(b)Simulation of the effective Hall-carrier concentration neff with varied defect layer thickness dD at two defect densities nD of 1019cm−3 and 1020cm−3, respectively. For the simulations, the mobility μD=1cm2/Vs in the defect layer and μGaN=400cm2/Vs in the GaN film were kept constant. The carrier concentration in the GaN film was assumed to behave according to nGaN=1018cm−3*exp(-30meV/kT)