Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T02:11:02.716Z Has data issue: false hasContentIssue false

A study of annealed GaN grown by molecular beam epitaxy using photoluminescence spectroscopy.

Published online by Cambridge University Press:  13 June 2014

Abigail Bell
Affiliation:
School of Physics and Astronomy, University of Nottingham, Nottingham, NG7 2RD, UKSchool of Electrical and Electronic Engineering, University of Nottingham, Nottingham, NG7 2RD, UK.
Ian Harrison
Affiliation:
School of Physics and Astronomy, University of Nottingham, Nottingham, NG7 2RD, UK
Dimitris Korakakis
Affiliation:
School of Physics and Astronomy, University of Nottingham, Nottingham, NG7 2RD, UK
Eric C. Larkins
Affiliation:
School of Electrical and Electronic Engineering, University of Nottingham, Nottingham, NG7 2RD, UK.
J. M. Hayes
Affiliation:
H.H.Wills Physics Laboratory, University of Bristol, Bristol, BS8 1TL, UK
M. Kuball
Affiliation:
H.H.Wills Physics Laboratory, University of Bristol, Bristol, BS8 1TL, UK

Abstract

Photoluminescence (PL) spectroscopy has been used to investigate the effect annealing has on molecular beam epitaxially grown GaN in different ambients. By observing the changes in the PL spectra as a function of ambient temperature and atmosphere used, important information concerning the origin of defects within GaN has been found. Samples were annealed in different atmospheres, (including oxygen, oxygen and water vapour, nitrogen and argon), different temperatures. In the 2.0eV-2.8eV region of the PL spectra, two peaks appeared at approximately 2.3eV and 2.6eV, somewhat higher than the usual yellow luminescence peak. We find that the 2.6eV peak is dominant for high annealing temperatures and the 2.3eV peak dominates at low annealing temperatures for the samples annealed in oxygen. When annealed in argon and nitrogen the 2.6eV peak dominates at all annealing temperatures. Changes in the PL spectra between anneals were also seen in the 3.42eV region. The 3.42eV peak is often assigned to excitons bound to stacking faults. Power resolved measurements indicate that in our sample the cause is a donor acceptor pair transition.

Information

Type
Research Article
Copyright
Copyright © 1996 Materials Research Society
Figure 0

Table 1Sample numbers with annealing parameters.

Figure 1

Figure 1.4K PL spectra of sample annealed in O2 and H2O at different temperatures. The position of the D°X peak shifts from 3.467eV to higher energy after annealing.

Figure 2

Figure 2.Power resolved PL of sample 63 annealed in O2 and H2O at 1000°C. The 3.418eV and 3.36eV peaks shifts with excitation intensity, typical of a DAP transition. The D°X peak, not shown here, is at 3.479eV and does not shift.

Figure 3

Figure 3.300K PL spectra of samples annealed in O2 or O2 plus H2O at different temperatures. Peaks at 2.3eV and 2.6eV, shown with an arrow, become stronger upon annealing in O2, this effect is even stronger when annealing in O2 and H2O.

Figure 4

Figure 4.Power resolved PL of sample 63 annealed at 1000°C in O2 and H2O. As the excitation intensity is increased the 2.3eV peak shifts to a higher energy suggesting a DAP transition. There is no such shift of the 2.6eV peak.

Figure 5

Figure 5.(a) A deep acceptor takes part in recombination from an electron on a shallow donor and the conduction band. (b) A deep donor level carries electrons that recombine with both a shallow acceptor level and the valence band.