Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T06:17:41.412Z Has data issue: false hasContentIssue false

Studying the effects of strain heating on glacial flow within outlet glaciers from the Heimefrontfjella Range,Dronning Maud Land,Antarctica

Published online by Cambridge University Press:  14 September 2017

Veijo A. Pohjola
Affiliation:
Department of Earth Sciences, Uppsala University, Villavägen 16, S-752 36 Uppsala, Sweden E-mail: veijo.pohjola@geo.uu.se
Jim Hedfors
Affiliation:
Department of Earth Sciences, Uppsala University, Villavägen 16, S-752 36 Uppsala, Sweden E-mail: veijo.pohjola@geo.uu.se
Rights & Permissions [Opens in a new window]

Abstract

A one-dimensional numerical thermodynamic model is used to study the effects of strain heating on temperature profiles along the flowline of two outlet glaciers in Dronning Maud Land,Antarctica,flowing down a steep escarpment. Measurements of ice surface velocities on the glaciers show higher speeds than surface speeds calculated using Glen’s flow law. These calculations are based on ice-temperature distributions excluding strain heating in the general heat equation. The incorporation of strain heating in the general heat equation produces higher ice temperatures,and calculated ice surface speeds that are close to the measured values. It is found that relatively short-scale temporal and spatial steps in basal topography are enough to drive the ice flow into a positive feedback loop as long as the bedrock step produces a stress that overcomes the advection of cool ice from the surface. In this case,where surface temperatures are –25°C,stresses of 0.4 MPa are enough to drive the base of the ice to the melting point within 102 years.

Information

Type
Research Article
Copyright
Copyright © The Author(s) [year] 2003
Figure 0

Fig. 1.The two glaciers in Heimefrontfjella, Dronning Maud Land, Antarctica: Bonnevie- Svendsenbreen (BSB)and Kibergbreen (KB). The base of the map is a SPOT image, and the topographic information is from the Institut für Angewandte Geodäsie (Frankfurt, Germany) map Sivorgfjella (1:25 000) and surface measurements (Pohjola and Stroeven, 1991). The dashed lines mark the boundary between the different ice flows in the area. The equidistance between contours is 100 m.

Figure 1

Fig. 2.Longitudinal transects of BSB (a) and KB (b). The position of the transects is shown in Figure 1. The gray area is bedrock, and the thick gray line is the ice surface. Measured center-line ice surface speed is shown in a separate panel above each transect.

Figure 2

Fig. 3.The thermal (a) and ice-speed (b) evolution from the model using input data from BSB. The distributions shown products of the steady-state thermal profile (S-S) using no strain heating, and with strain heating of the steady-state profile 2 0, 40, 60 and 85 years. The model of constant geometry was used in these calculations, and vertical advection was negligible in the strain-heat runs. (c) How vertical advection changes the thermal profile, using no vertical advection line), 0.25 m a–1 and 1m a–1. (d) The thermal and ice-thickness evolution using a constant-flux model (conservation of The distributions are shown as a product of the steady-state thermal profile (S-S) using no strain heating, and with heating of the steady-state profile after 80, 140 and 190 years. The vertical advection was set to 0.25 m a–1 in these runs.distribution shows the 80 years of strain heat from (a).

Figure 3

Fig. 4.Similar to Figure 3, but calculations for KB. Different from Figure 3 are the times shown in (a) and (b):10, 20, 30 and 35 years. (c) How the vertical advection changes the thermal profile, using no vertical advection (dashed line), 0.25 m a–1(a), 5 m a–1(c) and 10 m a–1(b). (d) similar to Figure 3d, with evolution shown after 35 and 55 years.

Figure 4

Table 1.Results from selected runs on geometry on BSB, as shown in Figure 3

Figure 5

Table 2.Results from selected runs on geometry on KB, shown in Figure 4

Figure 6

Table 3.Results from runs on BSB and KB, using the conservation- of-mass criterion

Figure 7

Table 4.Test of the sensitivity of ice speed on BSB by changing the form factor, f, the viscosity, Btest (as % of B(z)), the geothermal heat flux, Qg, and the surface temperature, Ts