Hostname: page-component-74656f9884-2dmjx Total loading time: 0 Render date: 2026-11-10T14:42:01.553Z Has data issue: false hasContentIssue false

Airborne Radio Echo-Sounding in Shirase Glacier Drainage Basin, Antarctica

Published online by Cambridge University Press:  20 January 2017

S. Mae
Affiliation:
Department of Applied Physics, Faculty of Engineering, Hokkaido University, Sapporo 060, Japan
M. Yoshida
Affiliation:
National Institute of Polar Research, Tokyo 173, Japan
Rights & Permissions [Opens in a new window]

Abstract

Airborne radio echo-sounding was carried out in order to measure the thickness of the ice sheet in the Shirase Glacier drainage basin and map the bedrock topography. It was found that the elevation of bedrock was approximately at sea-level from Shirase Glacier to 100 km up-stream of the glacier and thereafter it was 500–100 m higher. Investigation of the echo intensity reflected from the bedrock indicates that at ice thicknesses less than 1000 m absorption was about 5.2 dB/100 m, but at greater ice thicknesses echo intensity did not depend upon the ice thickness but became approximately constant. Where ice thicknesses were greater than 1000 m in the main flow area of the Shirase Glacier drainage basin, the reflection strengths of about 9 dB were greater than outside the basin. Since the increase in echo intensity was considered to be due to the existence of water, the strong echo observed in the main part of the basin supported an hypothesis that the base of the basin was wet and the ice sheet was sliding on the bedrock.

Information

Type
Research Article
Copyright
Copyright © International Glaciological Society 1987
Figure 0

Fig. 1 Map of the Shirase Glacier drainage basin (thick solid line). The trilateration network is indicated by a dashed line.

Figure 1

Fig. 2 Radio echo-sounding flight lines (thick solid lines).

Figure 2

Table I Specifications of Sounder

Figure 3

Fig. 3 a. Bedrock topography (thick lines) and surface topography (thin line) of flight J. b. Bedrock topography (thick lines) and surface topography (thin line) of flight 5.

Figure 4

Fig. 4 Map of bedrock topography.

Figure 5

Fig. 5 a. Relationship between E and h, flight 1. b. Relationship between E and h, flight 5.

Figure 6

Fig. 6 Map of the bedrock reflection coefficient, x, −40 dB > E > −60 dB; Δ, −60 dB > E > −70 dB; Δ, −70 dB > E > −80 dB; •, E < −80 dB.