Introduction

In connection with the deep drilling at Dye 3, south Greenland (lat. 65°11′N., long. 43°49′W.), a glaciological programme was carried out up-stream of the drill site. The programme included observations of surface topography, ice-thickness profiles, surface velocities, surface strain-rates, and accumulation-rate distribution (Reference Whillans, Whillans, Jezek, Drew and GundestrupWhillans and others, 1984; Reference Overgaard and GundestrupOvergaard and Gundestrup, in press; Reference Reeh, Reeh, Johnsen and Dahl-JensenReeh and others, in press).

Combining the results of these investigations with velocity–depth data obtained from down-bore-hole inclinometry measurements (Reference Gundestrup and HansenGundestrup and Hansen, 1984), the local mass balance of the ice sheet at Dye 3 can be estimated.

Equation of Continuity

Introducing a horizontal x—y coordinate system, the local continuity equation for the ice sheet may be expressed as follows (Reference MellorMellor, 1968):

(1)

where H is the ice thickness (in metres of ice equivalent), t the time, a the accumulation rate (in metres of ice equivalent per year), and u _m and v _m are horizontal ice-flow velocities in the x- and y-directions respectively, averaged over the ice thickness.

It is assumed that the depth-density profile is constant in time and space, and that the ice is frozen to the bed (the basal temperature at Dye 3 equals –13.2 °C according to Reference Gundestrup and HansenGundestrup and Hansen (1984)), so that there is no mass loss or gain at the bottom of the ice sheet. If we further assume that the x-axis is in the direction of flow, (Equation 1) can be rewritten in terms of the surface velocity and surface strain-rates:

(2)

where the subscript s indicates a value at the surface, and f = u _s/u _m is a shape factor of the horizontal velocity profile, which is assumed not to vary along the flow line.

The Data

The coordinate system applied is the one used by Reference Whillans, Whillans, Jezek, Drew and GundestrupWhillans and others (1984) with the x-axis coinciding with the ice-flow direction at the drill site. At this site, the following values of ice thickness and accumulation rate have been found: H = 2013 m of ice equivalent (Reference Gundestrup and HansenGundestrup and Hansen, 1984), a = 0.55 m of ice equivalent/year (Reference Reeh, Reeh, Johnsen and Dahl-JensenReeh and others, in press). The shape factor f can be calculated by means of the velocity profile given by Reference Gundestrup and HansenGundestrup and Hansen (1984). The profile was determined by subtracting hole positions obtained by integrating the hole inclinations measured in 1981 and 1983 respectively, ignoring vertical strain.

The 1981 inclinations were measured with the inclinometers in the drill (Reference Gundestrup and HansenGundestrup and Hansen, 1984), and have an uncertainty of about 0.5° at 6° inclination, which can probably explain the difference between the bore-hole- and geoceiver-determined surface velocities of 13.5 and 12.5 m/year (see below), respectively. The difference, however, introduces an uncertainty in the calculation of the shape factor f, the value of which ranges between 1.13 and 1.10 depending on which surface velocity is used.

Surface velocity at Dye 3

The position of station 1, 450 m from the Dye 3 deep drill site at direction 294° true, was measured by Mock in 1972–73 and 1975 (Reference MockMock, 1976). Based on these positions, Mock estimated the surface velocity to be 1.8–12.7 m/year, direction 056° to 061° true. Since the 1972 position was obtained with a few satellite passes only, and the 1973 and 1975 positions were obtained at a different site and referenced to station 1 by survey, it is difficult to estimate the error.

In 1980, 1981, and 1983 the measurements were repeated by University of Copenhagen (UCPH) (Reference Overgaard and GundestrupOvergaard and Gundestrup, in press), and in 1980 and 1981 the station was part of the strain net established by Reference Whillans, Whillans, Jezek, Drew and GundestrupWhillans and others (1984), who estimated the velocity to be 13.4 m/year in a direction 061° true.

Table I shows positions (referenced to the WGS-72 ellipsoid; a = 6378.135, f = 1/298.26) of station 1 obtained by processing the Mock and UCPH measurements using precise satellite ephemeris.

Table I.Positions Of Station 1

A linear fit to these data gives the velocity

The uncertainties are calculated on the assumption that all errors are random and therefore are formal errors. The 1972 position has a relatively high weight in this velocity calculation due to the long time interval to the next position determination. As the error in 1972 is uncertain and the definition of the satellite system was changed in June 1977, the 1972 position may be biased. If this position is omitted, the velocity is calculated to be

Surface strain may influence the calculation. The local longitudinal strain-rate is 0.63 × 10⁻³ year⁻¹ (see below). With a movement of the station of 138 m between 1972 and 1983, this corresponds to an increase of surface velocity of only 0.09 m/year, and consequently cannot explain the difference of 0.4 m/year between the two estimates.

In summary, 12.5 m/year is considered the best estimate, although the error of 0.1 m/year is too small due to non-random sources of error.

Surface strain-rates and ice-thickness gradient

As to the strain-rates ∂u _s/∂x and ∂v _s/∂y and the thickness gradient ∂H/∂x, two choices are possible: either apply strictly local values (averaged over distances of the order of 4 km) or regional values averaged over distances of the order of 20 km. Due to the rough basal topography up-stream of the drill site (Reference Overgaard and GundestrupOvergaard and Gundestrup, in press), local and regional thickness gradients and surface strain-rates show large differences, as illustrated in Table II. Results have been obtained from data presented in Reference Overgaard and GundestrupOvergaard and Gundestrup (in press) and Reference Whillans, Whillans, Jezek, Drew and GundestrupWhillans and others (1984).

Table II.Local and Regional Values of Surface Strain-Rates and Ice-Thickness Gradient at Dye 3

Results

There are arguments for applying local as well as regional values in (Equation 2). The values applied for accumulation rate, ice thickness, surface velocity, and shape factor f are local, thus favouring application of local values also for the remaining quantities in (Equation 2). However, due to the velocity perturbations caused by the rough basal topography, the short-distance gradient of the shape factor may not be negligible, as assumed by (Equation 2). The long-distance gradient of f on the other hand is more likely to be negligible, suggesting use of regional average values. Thus, since there is no clear preference for applying local or regional values, calculations have been performed with both sets. The results are

Using the following estimates for the standard deviations: s(u _s) = 0.1 m/year, s(H) = 10 m, s(f) = 0.015, s(a) = 0.015 m/year, s(∂u _s/∂x) = s(∂v _s/∂y) = 10⁻⁵ year⁻¹ (Reference Whillans, Whillans, Jezek, Drew and GundestrupWhillans and others, 1984), and applying values of s(∂H/∂x) as indicated in Table II, s(∂H/∂t) = 0.06 m or ice/year and 0.03 m of ice/year for the “local” and “regional” estimates, respectively.

Within the standard errors the two estimates therefore agree, and with 95% confidence, the present ice-thickness change at Dye 3 ranges between a thinning rate of 3 cm/year and a thickening rate of 9 cm/year. The largest contribution to s(∂H/∂t) comes from the uncertainty of the thickness gradient. Therefore, increasing s(u _s) to e.g. 0.25 m/year (as suggested by the calculation omitting the 1972 position above) will not change the confidence limits significantly.

Since the value of the accumulation rate used in the calculations is an average over about the last hundred years, the suggested small imbalance of the ice sheet does not reflect a short-term accumulation-rate anomaly, but rather a long-term trend persistent over at least the last several decades.

Discussion and Conclusions

The method used in this study to estimate the mass balance of the Dye 3 area has been applied previously to several locations on the Greenland ice sheet (Reference ShumskiyShumskiy, 1965; Reference MellorMellor, 1968; Reference MockMock, 1976). All previous estimates indicate large imbalances (up to more than 1 m/year), in some cases positive, in others negative. For example, Reference MellorMellor (1968) estimated that the Dye 3 area has a positive balance of 1 m/year. However, this large value is based on application of unrealistically large values of the surface velocity (50 m/year) and transverse strain-rate (−5.0 × 10–4 year⁻¹).

Generally, the previous mass-balance estimates suffer from a lack of precise data, and neglect of the differences between surface and average values. Reference MockMock (1976), for example, estimated the mass balance of the ice sheet at Crête (lat. 71°07^′N., long. 37°l9′w.) to be ∂H/∂t = −0.25 m/year. Using (Equation 2) with a = 0.29 m of ice equivalent per year, H = 3150 m, ∂u _s/∂x + ∂v _s/∂y = 1.24 × 10⁻⁴ year⁻¹ (Reference Reeh, Reeh, Clausen, Dansgaard, Gundestrup, Hammer and JohnsenReeh and others, 1978), u_s = 0 (Crête is on the ice divide), and f = 1.13 (the value at Dye 3), we obtain

i.e. a much smaller negative balance than estimated by Mock. Furthermore, the f-value at Crëte is likely to be considerably larger than at Dye 3 due to a relatively thicker layer of soft Wisconsin ice (see discussion below) and also due to the ice-divide effect discussed by Reference Reeh, Reeh, Clausen, Dansgaard, Gundestrup, Hammer and JohnsenReeh and others (1978) and Reference RaymondRaymond (1984). Changing f to 1.6 for example, which is not an unrealistic value for Crête, will change ∂H/∂t to a positive value of 0.05 m/year, which is in accordance with the observations of Reference SeckelSeckel (1977) for the period 1959–68, who determined the surface-elevation change in a profile across the ice sheet at lat. 70–72°N. by repeated precision levelling.

The suggested thickening rates of a few centimetres per year for the interior ice–sheet regions, however, do not necessarily mean that the Greenland ice sheet as a whole is at present gaining mass. Observations from the ice-sheet margin in West Greenland indicate that in general this part of the ice sheet is thinning and receding (Reference Bauer, Bauer, Ambach and SchimppBauer and others, 1968; Reference WeidickWeidick, 1975; Reference SeckelSeckel, 1977). Whether the gain in the central parts of the ice sheet, or the loss in the western marginal areas is the larger, cannot be determined on the basis of the data available.

Moreover, an even greater uncertainty concerning the mass balance of the total Greenland ice sheet arises from the fact that almost nothing is known about the mass balance of the eastern and northern parts of the ice sheet.

In connection with a search for possible explanations for the indicated surface-elevation increase in the central areas of the ice sheet the effect of the slow thinning of the layer of soft Wisconsin ice, which at present constitutes the bottom 10% of the ice sheet at Dye 3, and the contemporary thickening of the three to four times harder upper layer of Holocene ice (Reference Gundestrup and HansenGundestrup and Hansen, 1984; Reference Dahl-JensenDahl-Jensen, 1985), should be considered. This change will cause a thickening of the ice sheet, which can be calculated to be of the order of a few centimetres per year (paper in preparation by N. Reeh). Therefore, this effect should be considered a contributing cause of the suggested small surface-elevation change, on equal terms with past changes of accumulation rate and long-term changes of basal ice temperatures in response to the glacial-interglacial climate cycle (Reference WhillansWhillans, 1981).