Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T10:26:31.676Z Has data issue: false hasContentIssue false

Preferential orientation of spheroidal particles in wavy flow

Published online by Cambridge University Press:  12 October 2018

Michelle H. DiBenedetto
Affiliation:
The Bob and Norma Street Environmental Fluid Mechanics Laboratory, Department of Civil and Environmental Engineering, Stanford University, Stanford, CA 94305, USA
Nicholas T. Ouellette*
Affiliation:
The Bob and Norma Street Environmental Fluid Mechanics Laboratory, Department of Civil and Environmental Engineering, Stanford University, Stanford, CA 94305, USA
*
†Email address for correspondence: nto@stanford.edu

Abstract

We report a theoretical study of the angular dynamics of small, non-inertial spheroidal particles in a linear wave field. We recover the observation recently reported by DiBenedetto et al. (J. Fluid Mech., vol. 837, 2018, pp. 320–340) that the orientation of these spheroids tends to a stable limit cycle consisting of a preferred value with a superimposed oscillation. We show that this behaviour is a consequence of finite wave amplitude and is the angular analogue of Stokes drift. We derive expressions for both the preferred orientation of the particles, which depends only on particle shape, and the amplitude of the oscillation about this preferred value, which additionally depends on the wave parameters and the depth of the particle in the water column.

Information

Type
JFM Papers
Copyright
© 2018 Cambridge University Press 
Figure 0

Figure 1.The evolution of the polar angle $\unicode[STIX]{x1D719}$ as found by numerically integrating the dynamical system in (2.11). In all cases, $kA=0.2$, $H=10$ and $\unicode[STIX]{x1D714}=2\unicode[STIX]{x03C0}$, the initial orientation of the particle was set at $\unicode[STIX]{x1D719}(t=0)=0$, and the initial position was set to $x_{c}(t=0)=0$ and $z_{c}(t=0)$ such that the particle remained just below the free surface even at its maximum vertical excursion. Each curve corresponds to a different particle eccentricity; from top to bottom, $\unicode[STIX]{x1D700}=0.5$, 0.1, $-0.1$ and $-0.5$. In each case, $\unicode[STIX]{x1D719}$ asymptotically tends to a limit cycle of sinusoidal oscillations about a preferred value.

Figure 1

Figure 2.(a) Numerical solutions of the linearized equation of motion for $\unicode[STIX]{x1D719}$ (3.6) for $\unicode[STIX]{x1D700}=0.5$, 0.1, $-0.1$ and $-0.5$. The two larger values of $|\unicode[STIX]{x1D700}|$ are the steeper curves. Positive values of $\unicode[STIX]{x1D700}$ are shown with solid lines, and negative values with dashed lines; the difference is simply a $180^{\circ }$ phase shift. In all cases, $kA=0.2$, $H=10$, $\unicode[STIX]{x1D714}=2\unicode[STIX]{x03C0}$, $x_{o}=0$ and $z_{o}$ was chosen such that the particle always remained just below the free surface. (b) The same data shown only for short times, to make the phase difference between the positive and negative values of $\unicode[STIX]{x1D700}$ clearer.

Figure 2

Figure 3.The evolution of the polar angle $\unicode[STIX]{x1D719}$ as found by numerically integrating the approximation given by (3.12). In all cases, $kA=0.2$, $H=10$, $\unicode[STIX]{x1D714}=2\unicode[STIX]{x03C0}$, $x_{o}=0$ and $z_{o}$ was chosen such that the particle always remained just below the free surface. Again, each curve corresponds to a different particle eccentricity; from top to bottom, $\unicode[STIX]{x1D700}=0.5$, 0.1, $-0.1$ and $-0.5$. With the finite wave-amplitude correction in (3.12), we recover the oscillation of $\unicode[STIX]{x1D719}$ about a preferred orientation.

Figure 3

Figure 4.The particle orientational dynamics in the $(\unicode[STIX]{x1D712},\unicode[STIX]{x1D713})$ phase plane. At lowest order, the dynamics of $\unicode[STIX]{x1D712}$ and $\unicode[STIX]{x1D713}$ move along the unit circle at a constant rate with a superimposed oscillation (thin solid line). When accounting for finite wave amplitudes, they instead oscillate on arcs on this circle (thick lines). Data are shown here for the same cases plotted in figure 3. In all cases, $kA=0.2$, $H=10$, $\unicode[STIX]{x1D714}=2\unicode[STIX]{x03C0}$, $x_{o}=0$ and $z_{o}$ was chosen such that the particle always remained just below the free surface, and data are shown for eccentricities $\unicode[STIX]{x1D700}=0.5$ (lower right arc), 0.1 (upper right arc), $-0.1$ (lower left arc) and $-0.5$ (upper left arc).

Figure 4

Figure 5.The same curves of $\unicode[STIX]{x1D719}$ as shown in figure 1, now augmented with our predictions for the preferred alignment $\bar{\unicode[STIX]{x1D719}}^{\ast }$ ((3.33); solid horizontal lines) and the oscillation amplitude $A_{\unicode[STIX]{x1D719}}$ ((3.36); dashed horizontal lines). As above, from top to bottom the curves correspond to the eccentricities $\unicode[STIX]{x1D700}=0.5$, 0.1, $-0.1$ and $-0.5$.

Figure 5

Figure 6.The phase lag $\unicode[STIX]{x1D711}$ between $\unicode[STIX]{x1D719}$ and the wave plotted as a function of the eccentricity $\unicode[STIX]{x1D700}$, as computed from (3.41) for $kA=0.2$, $H=10$, $\unicode[STIX]{x1D714}=2\unicode[STIX]{x03C0}$, $x_{o}=0$ and $z_{o}$, chosen such that the particle always remained just below the free surface.