Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T15:54:12.159Z Has data issue: false hasContentIssue false

Gallium Nitride Growth Using Diethylgallium Chloride as an Alternative Gallium Source

Published online by Cambridge University Press:  13 June 2014

Ling Zhang
Affiliation:
Department of Chemical Engineering, University of Wisconsin, Madison, WI 53706
Rong Zhang
Affiliation:
Department of Chemical Engineering, University of Wisconsin, Madison, WI 53706
Marek P. Boleslawski
Affiliation:
Aldrich Chemical, Milwaukee, WI
T.F. Kuech
Affiliation:
Department of Chemical Engineering, University of Wisconsin, Madison, WI 53706

Abstract

Metal organic vapor phase epitaxy (MOVPE) of GaN has been carried out using diethyl gallium chloride (DEGaCl) and ammonia. The growth rate and efficiency of the DEGaCl-based growth decreases with increasing temperature when compared to trimethyl gallium (TMG)-based growth under similar conditions. Both low temperature buffer and the high temperature GaN layers were grown using the DEGaCl-NH3 precursor combination on the basal plane of sapphire and compared to similar structures grown using TMG and NH3. DEGaCl-based growth reveals an improved growth behavior under identical growth conditions to the conventional TMGa and ammonia growth. X-ray, Hall, and atomic force microscopy (AFM) measurements have been carried out on these samples providing a direct comparison of materials properties associated with these growth precursors. For the DEGaCl-based growth, the x-ray rocking curve line width, using the (0002) reflection, is as low as 300 arcsec on a 2.5-micron thick film. A RMS surface roughness of ∼0.5nm measured over a 10×10 micron area.

Information

Type
Research Article
Copyright
Copyright © 1999 Materials Research Society
Figure 0

Figure 1:The GaN growth efficiency, which is the ratio of the GaN film growth rate (µm/min) to Ga molar feed (mol/min) into the reactor as a function of temperature for both DEGaCl (-▲-) and TMGa (-●-) sources.

Figure 1

Figure 2.The growth rate of GaN is a function of the calculated Ga flux from the bubbler feed into the reactor for DEGaCl (-▲-) and TMGa (-●-) sources.

Figure 2

Figure 3:The GaN surface morphology was determined by Atomic Force Microscopy (AFM) for samples grown using DEGaCl or TMGa source. The sample images are obtained over a 10×10 micron area. The full range of height (Z) is indicated. The sample structure and related film properties are given in Table 1.

Figure 3

Figure 4:The change in GaN materials properties with growth temperature (Fig. 4a) and inlet V/III ratio (Fig. 4b) were obtained for films grown using the DEGaCl source. The structural quality was measured by x-ray rocking curves about the (002) and (104) Bragg reflections, symbols -▲- and -■- respectively. The carrier concentration (-●-) was obtained by C-V measurement.