Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T10:15:38.425Z Has data issue: false hasContentIssue false

On the pressure field, nuclei dynamics and their relation to cavitation inception in a turbulent shear layer

Published online by Cambridge University Press:  04 July 2023

Karuna Agarwal
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218, USA
Omri Ram
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218, USAFaculty of Mechanical Engineering, Technion-Israel Institute of Technology, Haifa 3200003, Israel
Yuhui Lu
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218, USA
Joseph Katz*
Affiliation:
Department of Mechanical Engineering, Johns Hopkins University, Baltimore, MD 21218, USA
*
†Email address for correspondence: katz@jhu.edu

Abstract

Cavitation inception in the turbulent shear layer developing behind a backward-facing step occurs at multiple points along quasi-streamwise vortices (QSVs), at a rate that increases with the Reynolds number (Re). This study investigates the evolution of the unsteady pressure field and the distribution of nuclei within and around the QSVs. The time-resolved volumetric velocity in the non-cavitating flow is measured using tomographic particle tracking, and the pressure is determined by spatial integration of the material acceleration. Analysis in Eulerian and Lagrangian reference frames reveals that the pressure is lower, and its minima last longer within the QSVs compared with the surrounding flow. The intermittent low pressure regions, whose sizes and shapes are consistent with those of the cavities, are likely to be preceded by axial vortex stretching and followed by contraction. Such phenomena have been observed before in simulations of stretched vortex elements. For the same axial straining, the pressure minima last longer with increasing Re, a trend elucidated in terms of viscous diffusion of the stretched vortex core. The impact of nuclei availability is studied under ‘natural’ and controlled seeding. Owing to differences in the saturation level of non-condensable gas, the microbubble concentration in the shear layer decreases with increasing Re, in contrast to the rate of cavitation events. Minor differences in entrainment rate into the shear layer also do not explain the substantial Re effects on cavitation inception. Hence, the Re scaling of inception appears to be dominated by trends of the pressure field.

Information

Type
JFM Papers
Copyright
© The Author(s), 2023. Published by Cambridge University Press
Figure 0

Figure 1.The experimental set-up: (a) a spanwise view of the test section with a backward-facing step. The two fields of view (FOVs) of the two-dimensional PIV measurements are marked in green (solid and dot-dash); the FOV for backlit cavitation imaging is marked in blue; and the tomographic PIV and holographic cavitation imaging areas are marked in red. (b) A magnified view of the inlet to the test-section with a tap for bubble injection and the V-shaped tripping grooves. (c) The bubble injector showing a couple of 60 μm diameter bubbles. A magnified view of a train of injected microbubbles along the bottom wall can also be seen in (a).

Figure 1

Figure 2.Optical set-up: (a) top view of the tomographic PIV system consisting of four cameras with lenses aligned perpendicularly to acrylic prisms. The sample area illuminated by a thick laser sheet is shown in green. (b) A downstream view showing the two-view holography set-up.

Figure 2

Figure 3.Mean flow structure: (a) a scaled velocity profile of the turbulent boundary layer upstream of the step, showing the log and outer layers. (b) Contours of the ensemble-average streamwise velocity at U = 16 m s−1. (c) Wall-normal profiles of ensemble average streamwise velocity at three streamwise locations at the indicated different speeds and corresponding Reτ.

Figure 3

Table 1.The reattachment length of the shear layer and the properties of the separating boundary layer for the indicated speeds.

Figure 4

Figure 4.Reynolds stress statistics in the shear layer. Contours of: (a) $\sqrt {{u_x}{u_x}} /U$, (b) $\sqrt {{u_y}{u_y}} /U$ and (c) $\sqrt { - {u_x}{u_y}} /U$ at U = 16 m s−1. (d) Wall-normal profiles at the indicated streamwise locations, and at four different speeds.

Figure 5

Figure 5.(a) Sample perpendicular images for U = 10.5 m s−1 showing the evolution of a cavitation event starting from the nucleus marked by the dashed circle at t = 0 ms. (b) The spatial distributions of ensemble-averaged void fraction for the indicated speed and cavitation indices. (c) The PDFs of length, diameter and aspect ratio of the cavities.

Figure 6

Figure 6.Sample snapshot top views of cavitation inception at U = 16 m s−1 at the indicated times. Data are recorded at 50 kHz. The flow is from left to right.

Figure 7

Figure 7.(a) Joint PDFs of cavity diameters and length at U = 10.5 and 16 m s−1 presented using a logarithmic scale. The black and red lines mark aspect ratios (AR = length/diameter) of 2 and 5, respectively. (b) Sample evolution of cavity lengths with time along with their images at selected instances. (c) The PDFs of the axial collapse and growth rates of cavities for the indicated lengths and aspect ratios.

Figure 8

Figure 8.(a–c) Several t-SNE 2-D representations of the 45-dimensional matrix used for detecting QSVs. The colours indicate the mean-centred and variance-normalized values of the specified quantities ($\omega$xy, λ2 and pressure). (d) The corresponding locations selected as QSV indicated as 1.0, and non-QSV as 0.0. (e) A comparison of correlations of negative pressure with λ2 and $\omega$xy inside QSVs detected by the k means clustering and conditional sampling based on the magnitudes of λ2 and $\omega$xy.

Figure 9

Figure 9.A sample sequence showing the evolution of detected QSVs at the indicated times colour coded by their pressure (a–c) and their streamwise vorticity (d–f).

Figure 10

Figure 10.Frequency (f) spectral density of the streamwise velocity fluctuations at y/h = −0.17, averaged over the entire span and axial extent of the tomographic PIV sample volume. Dashed line is a −5/3 slope fit used for estimating η.

Figure 11

Figure 11.Joint probability densities in a logarithmic scale of the QSV length and diameter at 1.45 m s−1 (a–c), and 5.3 m s−1 (d–f) for: (a,d) QSVs, (b,e) negative pressure (Cp < 0) regions within the QSVs and (c,f) low pressure (Cp < −0.1) regions within the QSVs. Black and red lines indicate aspect ratios of 2 and 5, respectively. (g,h) Conditional PDFs, at the velocities indicated in the legend, of the: (g) diameters, and (h) aspect ratios of the QSVs, low pressure regions in them and the cavities.

Figure 12

Figure 12:Comparisons between PDFs of the separation between two adjacent low pressure regions, conditioned on Cp < −0.1, at U = 1.45 and 5.3 m s−1, and the distance between two cavitation events along the same QSV at U = 10.5 and 16 m s−1.

Figure 13

Figure 13.The PDFs of the QSV: (a) strength, and (b) angles (in degrees) with the x, y and z directions at U = 1.45 and 5.3 m s−1; and (c) PDFs of the corresponding angles of the cavities.

Figure 14

Figure 14.(a) The PDFs of the pressure inside and outside the QSVs. Black curves are Gaussian distributions with the same mean and standard deviation as those of the pressure at U = 5.3 m s−1. (b) Pressure spectra averaged over the spanwise and streamwise directions at y/h = −0.17.

Figure 15

Figure 15.(a,b) The PDFs of the: (a) vortex stretching term, and (b) correlations between negative pressure and positive stretching; (c) PDFs of the axial strain rate in the QSVs.

Figure 16

Figure 16.The PDFs of the cosines of the angles between the: (a) vorticity and the principal strain rates outside, and (b) inside the QSVs; (c) the QSV axes and the local principal strain rates, and (d) the QSV axes and the local vorticity. Here, s1, s2 and s3 are the most extensive, intermediate and most compressive strain rate eigenvectors, respectively.

Figure 17

Figure 17.The PDFs of the strain state parameter (Lund & Rogers 1994). As illustrated, 1 indicates a ‘pancake’ structure, and −1, a stretched vortex.

Figure 18

Figure 18.The PDFs of the ratio of the: (a) radial viscous vorticity diffusion in the QSVs to the axial stretching, and (b) the diameter at the axial stretching limit to the measured QSV diameter.

Figure 19

Figure 19.The time fraction of the indicated low pressure events and their durations: (a) inside and outside of the QSVs at 5.3 m s−1, and (b) inside the QSVs for the two speeds. The dotted vertical lines indicate the scaled initial growth times of the cavities.

Figure 20

Figure 20.Lagrangian pressure–pressure correlations inside and outside the QSVs at the indicated speeds for: (a) the entire data, and (b) conditioned on Cp < −0.05.

Figure 21

Figure 21.Lagrangian correlations of pressure at time t (conditioned on Cp < −0.05 and $\omega$xy > 5U/h) with the following quantities at time t + Δt: (a) $\omega$xy (b) axial vorticity stretching and (c) contraction inside and outside of QSVs. (d) The average strain state parameter at time t + Δt.

Figure 22

Figure 22.Lagrangian correlations of pressure at time t (conditioned on Cp < −0.05 and $\omega$xy > 5U/h) within the QSVs with the following spatially filtered quantities at time t + Δt: (a) axial vorticity stretching, (b) $\omega$xy and (c) axial contraction. The spatial filter involves a 3-D Gaussian filter with standard deviation of 0.2 mm.

Figure 23

Figure 23.Lagrangian evolution of: (a) pressure change, (b) stretching and (c) vorticity when Cp is minimal at Δt = 0 (conditioned on Cp < −0.05 and $\omega$xy > 5U/h) at U = 1.45 and 5.3 m s−1. The error is determined from a bootstrap analysis involving 5 different subsets.

Figure 24

Figure 24.Samples of QSV segments as determined by the k-means clustering (in red) along with their detected axes.

Figure 25

Figure 25.(a,c) The pressure and (b,d) axial vortex stretching along the QSV axis at the indicated successive times, when the pressure is minimal at dt = 0 and dl = 0 (conditioned on Cp < −0.05 and $\omega$xy > 5U/h). (a,b) U = 1.45 m s−1 and (c,d) U = 5.3 m s−1.

Figure 26

Figure 26.A schematic showing the evolution of a vortex segment subjected to local stretching: (a) prior to stretching, (b) formation of secondary azimuthal rings that oppose the stretching and cause contraction and (c) formation of rings that oppose the contraction and cause extension.

Figure 27

Figure 27.A comparison of the Lagrangian evolution of the QSV radius based on the measured evolution of pressure when Cp is minimal at Δt = 0 ((3.2), dashed lines) with that of a viscous vortex subjected to stretching followed by contraction, both with a magnitude of |s| = U/h (3.3).

Figure 28

Figure 28.(a) The location of ‘natural’ bubble distribution measurements shown on the spatial distribution of cavities at 16 m s−1 and σ = 0.55. (b–d) The nuclei number densities for the indicated velocities and cavitation indices, all slightly below cavitation inception levels, in the: (b) free stream, (c) recirculation region under the shear layer and (d) shear layer. Dotted lines show the indicated slopes.

Figure 29

Figure 29.Data for controlled bubble injection at a mean tunnel pressure of 1.1 bar: (a) nuclei number densities in the free stream, denoted as FS, and in the shear layer (SL) for the indicated velocities. The sample areas are marked in the inset. (b) The corresponding vertical profiles of microbubble concentration.

Figure 30

Figure 30.(a) Sample trajectories at U = 16 m s−1 containing ‘trapped’ bubbles highlighted in red; and (b) a comparison of the vertical profiles of bubble mean streamwise velocity with that of the liquid. Error bars indicate the standard deviation.