On the basis of progressive acid dissolution the Thompson-Hower model states that mixed-layer glauconite/smectite and illite/smectite contain potassium in two structural sites: a mica-type K position (site 1) and a position of uncertain structural status more prone to dissolution (site 2). Site 2 was thought not to retain radiogenic argon (40Ar*). Using extensive progressive acid dissolution and K/Ar studies on a sized illite/smectite (I/S), determining the amount of K in site 2 is shown to be somewhat more complicated than previously thought because the dissolution pattern depends on acid normality. More important, site 2 fully retains 40Ar*, and no age correction is thus necessary as is required by the Thompson-Hower model, further affirming the geochronologic value of illite in mixed-layer clay. These data are also relevant to understanding the crystal and particle structure of I/S. Site 2 is probably a partly filled K interlayer that develops as an intermediate kinematic step on the way to being fully filled during the transformation of smectite to illite.

The methylation of the fibrous clays, sepiolite and palygorskite, should be facilitated by their large content of surface silanol groups and the low acidity and inaccessibility of coordinated water molecules. Infrared spectroscopy showed that the reaction of diazomethane with these clays resulted in the methylation of their silanol surface groups. The grafting of CH3 groups on the surfaces of these clays produced a decrease in the surface area due primarily to the lowering of the microporosity.

Montmorillonite-based catalysts were compared with an acidic ion-exchange resin of the type used industrially for the production of methyl t-butyl ether (MTBE) from methanol and isobutene or t-butanol. When 1,4-dioxan was used as solvent, Al3+-exchanged montmorillonites had about half the efficiency of the resin Amberlyst 15 at 60°C; they were, however, about twice as efficient at this temperature at Ti3+-montmorillonite or K10, a commercially available acid-treated bentonite. Montmorillonite exchanged with Chlorhydrol solutions to give interlayer [Al13O4(OH)2(H2O)12]7+ ions and pillared clays derived from such materials were poor catalysts, as was K306, a more drastically acid-treated bentonite- based commercial catalyst. Freeze-drying of the Al3+-clay before reaction to produce a more open, porous structure had no effect on its catalytic efficiency. The activation energy for the reaction of isobutene and methanol in dioxan was 44 kj/mole for an Al3+-clay catalyst compared with 25 kJ/mole for reactions catalyzed by Amberlyst 15. With no solvent (as in industrial processes), the rates of reaction were considerably slower for both the clay- and resin-catalyzed reactions. As has been found previously for resin-catalyzed reactions using stoichiometric amounts or an excess of methanol, the rate was proportional to the isobutene concentration, and the rate-determining step appeared to be protonation of the alkene. The performance of the Al3+-clay catalyst was increased by reducing the water content of the clay. In most reactions the clay catalysts were equilibrated at 12% relative humidity. Exposure of the clay to a low vacuum (10−1 torr) before use increased its catalytic activity from 50 to 60% of that of Amberlyst 15.

Weathering of a copper stratiform deposit (schist) at Salobo, Brazil, has produced two distinct Cu-bearing minerals from a biotite parent: vermiculite and a manganese oxide containing as much as 13% and 25% CuO, respectively. Manganiferous products were formed as the result of an interhorizon transfer of solutions through a fissure system. Thus, the structural orientation of the schists was a major factor in controlling the supergene concentration of Cu. The Cu-vermiculite formed by the weathering of Fe-biotite, although the unweathered biotites in the parent rocks were found to contain no copper, suggesting that Cu was supplied by weathering solutions. X-ray powder diffraction (XRD) and cationexchange capacity data for the Cu-vermiculite differ from those of typical Mg-vermiculite and are similar to those of hydroxy- Al-vermiculite. A comparison of the XRD pattern of the Cu-vermiculite with that of a Cu-free vermiculite indicates that Cu atoms are located in interlayer sites. Cu probably occurs in a brucite-like layer. The position and structure of the Cu K-absorption spectrum suggest that the Cu is divalent and exists in 6-fold coordination.

To test the ability of illitic clay minerals to retain argon, K/Ar ages were measured on grain-size separates from the Cretaceous Mancos Shale and associated bentonites that have been transformed into K-bentonite near the contact with a large Tertiary igneous stock. The ages of size separates of illite/ smectite from the K-bentonite nearest the contact were internally concordant and matched the hornblende K/Ar age of the stock. In contrast, K/Ar data from clay size fractions from shales adjacent to each K-bentonite were internally discordant with measured ages that were much greater than the age of the intrusion. Thus, significant radiogenic argon was retained by fine-grained detrital illite, even in shale samples very near the igneous contact. These results are convincing evidence that illitic clay minerals are excellent K/Ar clocks under conditions prevailing in sedimentary and diagenetic environments.

An unusual vanadium chlorite precipitated during the formation of a vanadium-uranium ore deposit in the Henry Basin, southeastern Utah. The ore deposit formed by reduction and precipitation of U and V in the presence of organic matter at the interface between a stagnant brine and overlying, circulating meteoric water. Some samples of the vanadium chlorite (heated before analysis) contain ≥ 10% V2O5. In fresh samples, most of the vanadium is in the trivalent oxidation state. X-ray powder diffraction data suggest that Fe and V are concentrated preferentially in the interlayer hydroxide sheets of the chlorite. A d(060) value of 1.52 Å indicates that the chlorite probably has a dioctahedral structure which is distended by the presence of octahedral Fe and V. The vanadium ore zone is flanked by peripheral zones containing perfectly ordered chlorite/smectite. This chlorite/smectite contains much less V than the pure chlorite. This chlorite may have formed by the progressive precipitation of vanadium-rich interlayer hydroxide sheets in the mixed-layer chlorite/smectite in the most reducing portion of the ore zone. The pure chlorite is a IIb polytype, which, for nonvanadiferous analogs, is ordinarily found in high-temperature environments; however, no evidence exists to show that these rocks have ever been exposed to elevated temperatures. In fact, the presence of unreacted smectite in a potassium-rich setting and the low vitrinite reflectance of coalified plant debris indicate a low-temperature history for these sediments.

A method using Li saturation and heating to 250°C to differentiate montmorillonite from beidellite and nontronite has been developed. The test utilizes three washings with 3 M LiCl and two washings with 0.01 M LiCl in 90% methanol to prevent dispersion. An 'infinitely thick’ sample (6–8 mg/cm2) on a glass slide is used to avoid the effects of the reaction of a thin clay film with sodium of the slide when it is heated at 250°C. Solvation with glycerol rather than ethylene glycol is used, because all of the Li smectites studied expanded to some extent in ethylene glycol after the heating. The smectites included several montmorillonites, a nontronite, and saponites. The presence of interstratified montmorillonite and beidellite layers was clearly shown by the test for several smectite samples, including the so-called beidellites from Beidell, Colorado, and Chen-yuan, Taiwan, and several soil clays. The test thereby provides more mineralogical information than the often-used arbitrary dividing point between montmorillonite and beidellite at 50% tetrahedral charge. Heating the Li-saturated clays at 250°C caused substitution of 35 to 125 meq/100 g of nonexchangeable Li. These amounts exceeded the changes in cation-exchange capacity plus Li by 4 to 21 meq/100 g, except for the end-member beidellite from the Black Jack mine, Idaho. Fusion with LiNO3 at 300°C could not be used to differentiate between smectites instead of washing with LiCl solution and heating to 250°C, because fused montmorillonite subsequently expanded to 18 Å with glycerol. Large increases in nonexchangeable Li were caused by the fusion of smectites, a vermiculite, and two partially expanded micas.